The remote control allows to communicate with the control system, to send to him information like the setpoint of temperature, hygrometry, the modification of certain parameters …

Thus a synchronization between these two components is necessary in the case of splits (for monoblocs this is done from the factory)

To synchronize:

  1. Press the synchronization button on the control board for 5 s. The green and orange LEDs light up permanently
  2. Press the button at the bottom left of the remote control (back arrow) until the INItrF message appears
  3. Confirm with the OK button
  4. The remote control displayed OFF and switches off
  5. The red light on the electronic board lights up

Your system is synchronized

Friax - Customer Service

We're currently closed.We're open again on Tuesday (26 September 2023) from 8:30 AM to 12:00 PM


Nous vous indiquerons un revendeur qui saura vous conseiller et qui répondra précisément à vos attentes

You have Successfully Subscribed!